Ashly FX - forsterker + dsp med wifi/nettverk
Enten du er ute etter en enkel mikseforsterker eller en styrbar forsterker med dsp muligheter - er Ashly FX svaret!
FX60.4 er en firekanals forsterker med innebygget digital lyd prosessor. Super enkel dsp oppsett via web grensesnitt. Koble telefonen din til forsterkerens wifi netteverk, og tast inn enhetens IP adresse 192.168.4.1 (se under "beskrivelse" for utfyllende informasjon).
4 x bal/unbal inn
1 x SPDIF inn
1 x SPDIF ut
4 x GPIO + mute/standbye
Forsterker
8 ohm: 4 x 60watt
4 ohm: 4 x 60watt
100V: 2 x 120watt
LAN og Wifi - info under beskrivelse
Network Services
FX amplifiers are configured via a web page interface launched from the amplifier using a TCP/IP Ethernet network connection. In order to access the web page interface, FX amplifiers must first connect to the browser device, or to the network used by the browser device. That connection can be made using a wired LAN (use CAT5, CAT5E, or CAT6 cable), the FX amplifier's built-in WiFi Access Point (hotspot), or a local WiFi network (Client Mode).
Static IP connection: Out of the box, the FX Wired LAN connection uses a Static IP address, meaning the browser must connect using a predetermined fixed IP address. The default IP address for a wired LAN connection on FX amplifiers is 192.168.64.100. A different Static IP address may be assigned in the FX LAN configuration page.
• WiFi Access Point (hotspot) Every FX amplifier offers its own dedicated WiFi access point, or "hotspot", for a direct wireless connection to a browser device with no outside network required.
1. With the FX amplifier connected to mains power, wait for the front panel WiFi indicator to illuminate green. This indicates the FX amplifier's Access Point WiFi is available.
2. Using a laptop, tablet, or mobile device, search for available WiFi networks. Connect to the WiFi network called "Ashly FX (+ model name + serial number)". The serial number is found on the rear panel. Enter the password, "password", which can be renamed later, then connect.
3. Once the WiFi Access Point connection is made, open a web browser and enter the IP address 192.168.4.1. The amplifier configuration web page interface will open. Click on the Settings>Wifi menu for further WiFi options including enable/disable WiFi, enable/ disable WiFi when connected to LAN, disable WiFi after 5/10/30 minutes, and reset.